8 Ft Aluminum Windmill Assembly
Turn the tail over, remove the Post-It tabs and place them on the other side flush with the edge of the tail. Apply the Yellow Pin Stripe Vinyl. Remove the Post-It tabs and trim the edges with a razor blade or Box Knife NEXT STEP
Continue reading about 8 Foot Aluminum Windmill – Green with Yellow Trim – 4
Next place the Post-it tab (you can reuse these on the back side and tail) on the tail lining up with the edge – pull the backing off from the yellow pin stripe trim and line it up with the Post-It notes on the tail. Press the trim down on the green vinyl, remove the [...]
Continue reading about 8 Foot Aluminum Windmill – Green with Yellow Trim – 3
Place the level on the mast head post. This post needs to be straight up on all sides - Vertically level. This post can be moved by placing the box end of the 3/4″ wrench over the post and pulling down on the sides and corners of the mast head. All four legs should be [...]
Continue reading about 8 Foot Aluminum Windmill Assembly – 6
Arrange the four legs so the ends with the nut sets are together. The ends of the tubes with the nut sets are the top and go into the mast head. Check to see if the Phillips head bolts on the splicer are up – (toward the outside) and the nuts on the splicers are [...]
Facebook
LinkedIn
Flickr
Twitter
Youtube